Lippel has as standard to test its machines before shipping to customers. They are hard tests of 24 hours in full operation where the maximum of the machine is required. All aspects are seen and the results must be within the specified. Various analyzes and data are made of temperature, vibration, consumption, cutting capacity and production and stored in our system. If they are inside the specified apecs, the machine is cleaned, the painting is finished and it goes to the final destination - a customer more than satisfied. In this latest test carried out on a PFL 500x900 M-C that is destined for Chile, the machine achieved the incredible mark of 182m³ of chip production in just 1 hour with the use of a 317 HP engine. It's an incredible number for such a compact machine with low power installed. We thank all the staff involved in the development of this super machine!